Silica gel products in the production of many problems is to pay attention to, need to operate in accordance with the process, a little careless words will lead to the quality of silica gel products is not good, what factors will affect the quality of silica gel products?Today, Xinjia silica gel to give you an analysis of the four elements that affect the product quality of mold silica gel manufacturers.

    First, the quality of silica gel products raw materials will cause silica gel products difficult to remove the edge, the poor quality of silica gel products customized raw materials its toughness is not enough, tear strength is also obviously insufficient, in the process of edge removal is obviously difficult to remove the edge.

    Second, the forming stage of the product is relatively thick, so although the rough edge is relatively thick, the thickness of the increase is obviously also caused by the difficult side.

Three, vulcanization environment elements, vulcanization temperature should be suitable, too high too low problems will cause difficult to remove edge, at the same time vulcanization time this also needs good control, vulcanization time is too long will cause goods become brittle, vulcanization time is too short will cause no effect in the stage, so the stage of vulcanization must be controlled. 

    Four, molding mold this problem, if the mold self-disassembly design is unreasonable, molding mold is too long, molding mold wear is serious, molding mold quality is not qualified, these situations will lead to the production of molding is difficult to remove the edge.

    Audit drawings: mold silica gel manufacturers are generally customized according to the needs of assembly or modeling structure needs of separate mold production, then the integrity and accuracy of the drawing is very important, it directly determines whether the silica gel products can be a trial assembly qualified?Assembly if the design is too large, there will be stuck key phenomenon;Silica gel products customized in the design as far as possible to do negative tolerance, because silica gel is elastic, too large assembly is too loose, easy to fall off.

    Do you understand the above factors clearly?If you are a mold silicone manufacturer, will you pay attention to the above problems?