Trademark silica gel material belongs to the meteorological method of silica gel, in line with food grade contact standards, colorless and odorless surface.Mainly used for trademark LOGO and other production.The ratio is usually 10:1 or 1:1, and the ratio must be matched by an electronic scale according to the mass, because the density of the two components is not the same. If the measuring cup is used, the uneven ratio will lead to poor local curing effect.In the process of operation and use, it is not allowed to contact with nitrogen, phosphorus and sulfur. If the contact will lead to the trademark silicone material is not solidified, which will lead to unnecessary waste of cost. Before the test, skin test can be done to reduce the waste of cost.The more common misunderstandings are such as someone smoking in the air or placing heavy metal gas, the operator smoked, the use of stirring and scraping tools contain these. 

    The operation time of the trademark silica gel material with a good ratio is relatively long, usually the time is 24 hours at room temperature, and there is sufficient time to use. It is recommended to estimate the dosage of a good day, and to avoid unnecessary waste with how much is used.In fact, the production of trademark silica gel is relatively simple, which is scraped onto the copper mold by scraping process and then heated for rapid prototyping. The temperature is 120 degrees and the curing time is about ten seconds. The specific temperature will be affected by the thickness of the trademark.The reason for choosing copper molds is that they have faster heat transfer and long service life.If other die relative to the heat transfer and wear resistance are not as good as copper die.

    The finished trademark silica gel needs to be placed for 24 hours before it is put into production and the effect is better.Trademark silica gel raw materials also have adhesive relay, the above is a separate trademark silica gel production, and with the finished clothes made together.